FER-MET®
Wrapped steel bearing, inner and outer tension bushing, Spring steel, DIN 1498/1499
TOLERANCE DETAILS
Housing Ø
H8
Bushing inner-Ø after mounting
According to DIN 1498/1499
Shaft tolerance
Based on customer’s requirement [N/mm2]
SHAFT MATERIAL
Hardened steel (C45 recommended) Hardness +- 48 HRC
PROPERTIES
FER-MET® is a maintenance-heavy material, it has extremely high load capacity, very wear-resistant and is suitable for heavy operational demands with impact loads.
MAINTENANCE
Sufficient lubrication is necessary.
MOUNTING ADVISE
Housing: Mounting bevel min. 1.5 mm x 15-45° Shaft: Mounting bevel 5 mm x 15°, edges rounded
CAPTION
* For higher requirements – e.g. higher temperature ranges – different materials are available in this category.
** The listed values in the material properties are valid for optimal operating conditions. By changing the conditions of application, e.g. an increase in the sliding speed or strain, these values could shift.